EVERPURE SPA-400 FILTRATION SYSTEM
Everpure’s SPA-400 addresses the issues associated with water quality in the bathroom by reducing unwanted lead, particulate and chemical impurities and retaining healthful minerals such as fluoride, making it the perfect water source for teeth brushing and a healthy mouth. The SPA-400 is designed to connect to your existing lavatory faucet.
This filtration system does not require a second dedicated filter faucet. They can be connected to any existing faucet you have in your home such as your kitchen, bathroom, or kitchen island prep sink faucets. These utilize full flow technology that allows filtering water with your existing faucet flow rates.
The SPA-400 delivers water at a 2.2 gal/min flow, and brings the convenience of filtered water to your home spa, master bath, children’s or guest bathroom.
GENERAL INSTALLATION / OPERATION / MAINTENANCE REQUIREMENTS
This drinking water system must be maintained according to the manufacturer’s instructions, including replacement of filter cartridges. The substances reduced or removed by this system are not necessarily in your water. Read the performance data sheet.
It is recommended that before purchasing a water treatment unit, you have your water tested to determine your actual treatment needs.
Space required: 5W x 15H x 5D in (13W x 38H x 13D cm) including 2-1/2 inches of clear space under unit for cartridge change.
Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected water that may contain filterable cysts.
A separate drinking water faucet is required.
Install vertically with cartridge hanging down.
Use minimum length of tubing possible.
Flush new cartridge at full flow for three minutes to purge air.
Replace cartridge when capacity is reached, or when flow becomes too slow, but at least annually.